Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are planning to implement the below setup, we decided to use EtherChannels using LACP to equally load balance the traffic on both ISP circuits. When either of the circuit disconnect or have a problem, both switch will not received a LACPDUs and th...
I have 3850 switch running in version 16.6.8 and few interfaces having packet drops, like connections going to access points.after a bit of research I come up with this configuration. Is this correct? This 3850 switches are use only for end users (wi...
I'm working with ISE in my home lab and I noticed there is no "Policy set" in under policy menu webui. how to enable it?Service Identity Engine, Endpoint Security
I would like to confirm if I can upgrade directly the IOS image and rommon without intermediary steps? as shown below? CURRENT IOS IMAGE03.04.04.SG NEW IOS IMAGEcat4500e-universalk9.SPA.03.11.04.E.152-7.E4.bin CURRENT ROMMON15.0(1r)SG2 NEW ROMMO...
Hi Experts, I need your input to check if my procedure are correct. I will be upgrading our switches but I want to reload the entire chassis to make the upgrade simple. Below are the sequence. Please let me know your feedback. thank you Step 1: Copy...
This are the configuration that I just applied in the 3850 switch. I will observe in the next few days/weeks.!qos queue-softmax-multiplier 1200!XXXXXXXXXXXXXXX#sh run | sec policy-map QUEUE1policy-map QUEUE1class class-defaultpriority level 2queue-bu...
This is the config***************************!qos queue-softmax-multiplier 1200!ip access-list extended ACL_QUEUE1permit ip any any!class-map match-any CMAPQUEUE1match access-group name ACL_QUEUE1!policy-map QUEUE1class class-defaultbandwidth percent...
