Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi GurusI have a requirement where one of our partner is planning to connect to our datacenter using a dedicated leased line.As per our partner, they will engage a Leased line vendor for this. This vendor will terminate the leased line ( Single mode ...
I have a question regarding "mac address" command under "failover group"If I am using 4 contexts (Context-A, Context-B, Context-C, Context-D)and each context has 4 subinterfaces assigned out of which "outside interface is shared by all contexts"What ...
Hi guysIf I am using source nat in ACE (One IP address 10.10.10.200) used for all client address translations. What would be the difference between the nat-pools configured with different netmask. What is the recommended netmask for pat, 255.255.25...
Thank you all for the valuable input.Comm Room at the colocation facility is not far from our cabinet. (Our cabinet is on 1st floor & the Comm room is on 2nd floor) same building.Distance between our partner Data Center & Our location is currently no...
So the cross connect will also be SMF?We are in process of selecting a router that can support this. What would be the cost effective solution for this? Distance is not unknown.ThanksA.
Gilles Thanks a lot. It makes more sense now. I posted another question for an ACE design validation. Could you please validate thisI am planning to deploy ACE module in following manner: > ACE will be in one arm mode ( Only one vlan connected to t...
