I see this when I'm consoled into the ap and ap is booting up.I think these are "old orphaned" commands from the "autonomous ap" configuration.

I see this when I'm consoled into the ap and ap is booting up?I think these are "old orphaned" commands from the "autonomous ap" configuration.

Yes I know. But hopefully I can swipe these "incorrect commands" from the ap when I'll connect the ap to the wlc.Thanx

Thanx for your advice. It works now! I used archive download-sw /forced-reload tftp://[ip]/c1250-k9w8-tar.defaultIt's a little bit confusing, that I can't use the Upgrade Tool for these new AP 1250 also. But anyway...Now I got some unrecognized comm...

I have the the same problem - but with a 1250 AccessPoint!I tried the Autonomous To Lightweight Mode Upgrade Tool 3.0, 3.2 & 3.4.I used following "Autonomous To Lightweight Mode Upgrade"-Images:c1250-rcvk9w8-tar.124-13d.JA.tarc1250-rcvk9w8-tar.124-10...