Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Can you set up a frame relay circuit with a size of 386 with a WIC-1DSU-T1-V2? or does a frame relay circuit require a different card? It looks like I could use a WIC-1DSU-T1-V2 from what I have read. it is on a 2811 running IOS 12.4Thanks
Hi. I am trying to forward traffic to our VPN server. device is an ASA 5505 running v7.2I have followed these directions from cisco that were taken from the URl:http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186...
Hello,I have an issue where I have an issue at one of my remote sites. I can not ping any node on another network from this site. I can ping the next hop router, but nothing that is on the next hop. I do a trace and it stops at the next hop. However,...
Sorry,Yes I am using PPTP on a microsoft 2003 server setup for VPN. From what I gather, the only two two ports you need to worry about are tcp pptp(1723) and IP GRE(47). I can connect to the server from a computer when i try inside, and it works fin...
i have static statements on both. Although, with RIP or EIGRP, I would not think it was necessary to add a route, unless it was for a default route. One thing I noticed is that after I configure eigrp, and I do a "show ip eigrp interface" the only in...
I enabled eigrp on all my routers(all cisco) but no routes are being sent over my serial interfaces. The routers at my corporate office, which are connected via Ethernet, do however. When I do "show ip eigrp neighbors" i can see the neighbors on the ...
