Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Oups, wrong forum, how to change it ? Thanks--------------------------------Hi all,I need you advise and experience. We have a CISCO ASA 5510.We also use an ESX server. On one VM, randomly, the server is not accessible from the outside, but ok if con...
Hi all,Regarding to our ISP, our connection is OK (means 10Mb 1:1, burst 100).So upload and download should reach up to 10Mb.But, in fact, download is close to 10 000 kbps, which is perfect.On the other side, upload only reach 2 800 kbps, in real goo...
Hi all,We have a symetric 10 Mb line. But input is not more than 3 Mb, output is for sure around 10 Mb...I am trying to identify the bottleneck of it. I put everything in 100FD. Even the switch to which the asa is connected to.When i use the command ...
Hi all,I configured an ipsec vpn access with the ASDM wizard. The connection is fine, but i am unable to see anything, the only interface i can ping is the outside one.Without VPN, i can LAN 2 WAN, LAN 2 DMZ and WAN 2 DMZ.How can i have the same (acc...
Hi all,I have a DMZ with actually 2 servers.I need to limit bandwidth to one of them to 4 mbps. I don't find clear information, i found a link in few different forum that seems to answer my question, but it is dead link(http://www.cisco.com/en/US/pro...
I have a lot of collisions. Below a sh int of the outside interface.How to identify where does it come from ?Thank you,------------Interface Ethernet0/1 "outside", is up, line protocol is up Hardware is i82546GB rev03, BW 100 Mbps, DLY 100 usec Full...
Well ..... PEEEERFECT ! Yes, it is the web server public address. So i took out the route you gave me and added "static (dmz,inside) x.y.50.144 10.30.30.30 netmask 255.255.255.255 "Thank you !I have "static (dmz,inside) 10.30.30.30 x.y.50.144 netmask...
So i added "route dmz x.y.50.144 255.255.255.255 10.30.30.1 1"Works better, i mean, now, the message is more informal but i still cannot access web server, the only infomation i have is "Built outbound TCP connection 1978 for dmz:x.y.50.144/8080 (10....
Good news, i did not know, i thought i had to exclude them because of network and broadcast.I will test all of it as soon as i will have those IP. But in theory, everything should work Thanks for your help,
I had a similar issue with error message SYN Timeout accessing a web server in a DMZ from the outside, i had no return from the outside.(http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Security&topic=Firewalling&topicID=.ee6e1fa&fro...
