Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I need copy a user with type 5 password from another device, I have 2.5.7.85 firmware installed and the "username" command don't have the same parameters described on CLI guide available on cisco site (refer to 2.4.5 version).Have you any sugg...
Hello,I have a couple of SG250X -24 port wit firmware 2.5.7.85, after a while the web interface is not more reachable through https protocol, I need to enable the http server via cli.I upgraded the firmware from 2.4.0.94 version to try to resolve thi...
Yes, I know but on the CLI guide the username command permit add new user with a crypted password, I don't know the true password so i can't create a new user through web interface or CLI.
Hello,thank you Martin, it's necessary to enable the secure web server from CLI and not from web interface, followed your suggestion the problem was resolved. Thank youBRGiovanni
A lot of "Failed to load resource: net::ERR_EMPTY_REPONSE" and "Uncaught TypeError: Cannot read properties of undefined (reading 'setTokenWithError')" ... nice BRGiovanni
