Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys I bought a few routers 2911. I've been having some problems trying to figure how to export a packet capture. I created the monitor capture and then tried to exported but it failed. monitor capture buffer NEW export tftp://11.11.11.2/new.pca...
Hello guys I'm doing a lab to lear about SSL VPN session. I followed the lab and the annyconnect client was able to connect successfully. However, I do not see the network from the external router and I'm unable to reach it. Not sure what might be mi...
Hello guys I styuding for the ccna securiy and I tried to establish a site to site vpn between an ASA 5506 and a 2911. I followed the configuration guide from the documentation and from INE but phase 2 of is not coming up. Please find the logs I got...
Hello Guys I hope you can help me out with this, I getting familiar with the ASA firewall. So I bought an ASA 5506, I've been wathing the INE course for the CCNA security and my lab was working ok. However, after a while I was unable to ping from the...
Hello Sheraz Thanks you were right, the issue was on the internal router. I changed the static route and it worked, but I;m curious about the issue because the log I was getting from the ASA was saying that there was no policy. Why do you consider th...
Hello Sheraz This is a basic setup just to get familiar with the concept. NAT is not being implemented. I'm attaching the network diagram and the configuration for the routers. OUTSIDE ROUTERcrypto isakmp policy 1encr aes 256authentication pre-share...
Hello This is the configuration I have for the extenal router and the ASA. Thanks for the quick response. Router#show run | section isakmpcrypto isakmp policy 1encr aes 256authentication pre-sharegroup 2crypto isakmp key cisco address 20.0.0.254crypt...
