About Balloonhead

Balloonhead · 10-09-2015

Just curious if this is even possible. If so what would be my steps in making this happen outside of the base switch/firewall standard failover setup?

Balloonhead · 09-14-2015

Trying to setup a isolated vlan as a dmz environment on my asa. Below is the VLAN config. I can ping out to the internet but I am unable to resolve any ip addresses so no web access. I have enabled dynamic NAT on the address range. Any help would be ...

Balloonhead · 09-11-2015

Not use to these small business switches. They speak a little different language. Trying to isolate a vlan to just allow internet access but not LAN access. Involves two sg300 10 ports and a 5505 with full security license. Unable to pass traffic to ...

Balloonhead · 08-24-2015

I am curious what the best way would be to redistribute routes using ospf. The company I currently work for has 10 sites connnected via ipsec vpn tunnels. A vpn tunnel from each site to each site. I would like to redistribute the routes from all site...

Balloonhead · 09-16-2015

Jon, Thank you for pointing out my ignorance. I forgot that I had added that to to the dmz interface by mistake. Thanks for the second set of eyes. :)

Balloonhead · 09-12-2015

Apparently I am reading your mind because I literally just realized my bonehead move! It's been a long night. Thank you SO much Richard!

Balloonhead · 09-12-2015

Edited the above post when you were typing your response apparently. :) I set a pc up on that vlan and changed the gateway. I can now ping the asa and everyone sees the mac address etc. I am still unable to get to the internet from that VLAN though. ...

Balloonhead · 09-12-2015

All addresses are static. I have a VERY small dhcp pool for someone who just plugs in. All devices on VLAN 1 get to everything route outside is set with PAT working properly. I can manage the ASA and switches from devices on VLAN aka 10.0.0.0/24. I S...

Balloonhead · 09-12-2015

Can ping the switches on that vlan but not the asa from the switches. Yes, security plus. Sorry wrong terminology in first post. You're also correct that the acl will not help me in this situation. This is being setup to keep the thermostat etc for a...

Member Since	‎08-24-2015 11:08 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	11

User Statistics

User Activity

5505 failover with dynamic ip

5505 DMZ DNS issues

Trunking help sg300 to 5505

OSPF question

Jon, Thank you for pointing

Apparently I am reading your

Edited the above post when

All addresses are static. I

Can ping the switches on that