Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a random issue with a brand new S170 where the M1 (mgmt) port goes offline after about 3-4 hours of uptime. Rebooting (soft reboot) brings the M1 port on-line. P1 stays connected. P2 is not being used.This unit is a newer unit that was repl...
Found the fix. Our interfaces were overlapping with their subnet masks.M1 = 10.2.254.251/24P1 = 10.2.1.251/16I changed it to this:M1 = 10.2.254.251/24P1 = 10.2.1.251/20All good now. I am 100% sure this was the problem. Thanks for the guidance Ataz...
We have cleared the ARP table on our switch but to no avail. Could you offer some basic suggestions as to troubleshooting this? I don't believe we have any static ARP entries when I look at the ARP table (show arp). There don't seem to be any dupl...
As a generic troubleshooting method, I changed the IP address of the M1 interface in order to see if there was a conflict. I am a bit of a network novice so this may be way off base.I do believe you are onto something with your response and I will b...
