Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone,My name is Prabjeet and I am working for New Zealand Automobile Association as a Network & Voice Engineer for past 8 years.We have migrated our whole network to Meraki last year.Looking forward to learn a lot and share some of my learning...
Hi There,I have Cisco ASA 5510-K8 where I can't use Eth 0/3. Below is the Sh ver output which says Eth 0/3 is not licensed. It has base license at the moment and I believe that we need to have security plus license to enable Eth 0/3 but would like to...
Hi All,I am new to the community and posting for the first time. I am currently having an issue in our company network where remote sites traffic coming to head office and then flowing via gig link to our data center instead of going straight to Data...
Hi There,I am trying to setup site-to site VPN with SRP527W firmwar (1.02)Example:Site A - IP Address - 192.168.1.x /24Site B - IP Address - 192.168.2.v .24VPN Status Showing connected. Routing table showing ipsec0 interface for remote location traff...
