Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi GuysI am having some issues with getting my asa to update my dynamic ddns provider when my IP changes, can someone help me configure debugging for ddns on the asa.I have tried "debug ddns" and than I get a message "debug ddns enabled at level 1" a...
Hi GuysI have setup a DDNS account with Dynu, and everything is working fine, I just have one issue, I am getting a DHCP address from my ISP and when this address changes it does not update Dynu DDNS service, so I opened a support ticket with them an...
Hi GuysI was wondering if you can help me, I have a cisco asa 5515-X and I have created three internal networks in the range of 192.168.0.1 security level 60, 192.168.2.0 security level 100 and 192.168.4.0 security level 50 and management is 192.168....
Hi All
I was wondering if you can help me out, I have loaded ios c2600-ipbasek9-mz.124-25a.bin on the router, for some reason it boots twice as you can see details below, it says %SYS-6-READ_BOOTFILE_FAIL: flash:c2600-j1s3-mz.123-26.bin File boot fai...
Hi RobertI am still waiting for a solution, I have another thread here : https://community.cisco.com/t5/firewalls/cisco-asa-5515-x-ddns-debug/m-p/3937516#M182182I am waiting for Balaji to load my config and see if he can get it working, updated will ...
Hi BalajiI have attached the config, I have removed crypto config as that is not required and have changed some areas to xxxx which contain username and password and hostname.Thanks
