Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
@Preston Chilcote Couple simple commands I used to test (from a new SSH connection):sh run int gi1/0/1sh runconf tThose should all be fine - unless it's expecting me to now enter the entire command (like show running-config). That would be a departur...
@Preston Chilcote I tried your solution, and it doesn't fix the terribly slow response times from the switch to any commands entered, either in global enable or config mode. In a large, active network we're changing interfaces pretty regularly. Waiti...
I've been looking for a way to remove the "ip domain-lookup" command, too. We have Catalyst Center Version 2.3.7.7-70047. As with @GreyElf, we have the same STIG requirements. Whenever the suite touches a switch it forces the command back into the co...
