Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm getting this error when I try to downgrade a 1231 from LWAPP to Autonomous mode. The transfer takes place and then it starts extracting file and ends with this message.Any ideas?
I recently did a conversion of 125 AP's, both 1231's, 1121's and 1242's this past month. The problem is I have about 10 that didn't get joined to the controller. It seems like a SSC issue but i'm not sure because I see the ssc on the controller. I tr...
It doesn't recognize the archive tar command or archive command for that matter.I ran across this http://www.cisco.com/en/US/ts/fn/620/fn62379.htmlIt shows the exact log messages that my AP has on it. I'm not sure what their work around means though....
Yes I can see the file transfering. Then it goes to inflate it and errors out and continues to load the LWAPP config.Is there a way to blow away the .tar file and just copy the new one (autonomous) over to the flash?
I downloaded and tried the 3cdaemon and get the same result.The odd thing is this happens on more than one 1231 AP. They were all upgraded via the Upgrade tool but never could join the WLC. I just want to get an autonmous IOS image on to try the upgr...
