Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am setting up an ASA5505 for IPsec VPN and cannot get the VPN client to connect.The modem/router at the ASA site is a ZyXel 660. How do I get the ISP-provided DSL WAN address to the ASA5505? Port forwarding on the ZyXel? Basically, forward all traf...
This problem was resolved by the following steps:- Put the DSL modem/router into bridge mode.- Reset the ASA to factory defaults.- Run the Startup Wizard, setting the outside vlan to get an IP via DHCP.- Run the VPN Wizard.- Issue two commands: cr...
I did get bridge mode configured and the IP successfully passed to the ASA's outside network. I am now able to connect using the VPN client, but cannot ping any addresses on the inside network. The config file is in a previous post in case that helps...
I configured the ZyXel for bridge mode and proceeded with the pppoe setup on the ASA.The outside vlan got an IP, but I couldn't get out from the inside vlan.A call to my DSL provider to see if there was a pppoe username and password revealed that the...
