Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello! I have a router cisco 1811 with 2 of the WAN interface. I have to configure the WAN connection with two different ISPs to allow failover. My current setup is as follows: ip route 0.0.0.0 0.0.0.0 ip_isp-router_1 ip route 0.0.0.0 0.0.0.0 ip_isp-...
Hi, I have my router cisco 1811 K9, with Failover and LoadBalancing... and with the NAT rules to pass through the respective ports to have Web and Telnet Access...now I'm trying connect from an external connection, with the windows xp client VPN cone...
Thanks John, I'm going to do that. But still can't access internet from the LANIf I set NAT yes I can, but this only works with one WAN, and the second WAN doesn't work when the first fails.
Thanks Giuseppe!I meant NAT, no NTA, jajaj excuse meYes, I need to use one ISP to access to the internet and in case this ISP failure, use the second ISP automatically.Show running-config:!!interface FastEthernet0 description $ETH-WAN$ ip address 200...
