Can anyone tell me as i have I recently added an inside router to connect a second inside network to my PIX Firewall. Users between the Cisco Secure PIX Firewall and inside router can get to the Internet just fine, but they cannot talk to this new, i...
Can anyone tell me as i have I recently added an inside router to connect a second inside network to my PIX Firewall. Users between the Cisco Secure PIX Firewall and inside router can get to the Internet just fine, but they cannot talk to this new, ...
Hi,Can someone tell me if i need to check the following traffic is being passed on the PIX?Source: x.x.x.246destination: 172.18.46.75what is the command to figure out on PIX?& also need to check for hits on the access-list for:-access-list acl-test p...
Hi,Can someone tell me the commands/access-lists on PIX to allow the below:source: 10.10.2.3destination: x.x.x.20ports: 21,23,1530, 18102, 18103Please give me the commands to run on PIX?Regards,Vin
Can someone tell me if i can use supernetting for the below subnets rather using multiple entries on PIX?10.91.100.0 / 2510.91.102.0 / 2510.91.104.0 / 2510.91.106.0 / 2510.91.108.0 / 2510.91.110.0 / 2510.91.112.0 / 2510.91.114.0 / 25& it wil be very ...
there is a RDP object-group exists in the config. i want to either change it to some other port number or want to create a another rdp group and assign new port number -pls tell me how to write commands for that?
HI,I need to use another port number for RDP protocol- if i use rdp protocol in access list but before using it - want to change the port number from 3389 to some other?how can i do that??
All together i have to write the following commands: (am i right)nat (inside) 1 10.1.0.0 255.255.0.0 nat (inside) 1 10.3.0.0 255.255.0.0 nat (inside) 1 10.8.0.0 255.255.0.0 access-list policy_nat extended permit tcp 10.1.0.0 255.255.0.0 host 172.16.2...
