Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Folks,I just re-install the IOS on my router (via XMODEM) - I now want to put SDM back on the box, but I can't connect to the router with the SDM installer? I can connect via HTTP/HTTPS to the router via it's default IP address (although the page...
Hi Folks,I've got an 877 and by mistake I delete all files in flash. After a power cycle the router is dead and I can't get in (not tried console cable yet) - if I console in what is the best command to reset it back to factory reset?Cheers.M
Hi Folks,I have a question about my Cisco 877, I am running "c870-advsecurityk9-mz.124-20.T1" but when I try to set-up QoS under SDM it says I am running the wrong IOS. Also under Firewall and ACL I am not able to set-up any P2P protection (again it...
Hi Folks,I have a quick question. I'm using 12.5 version of SDM. However, when I go to the Firewall / ACL tab the interface has changed massively to what it was before I built my firewall. I'm still using the same version of IOS. The interface no...
