Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
All, I need to have a Level-1-2 router inject a default route (set the attached bit) always into Level 1, regardless of connections to another Level 2 area or not, kind of like "default-information originate always" in OSPF. Is this possible?Chris ...
This sounds possibly like receive-side buffering. See this URL: http://www.cisco.com/en/US/products/hw/modules/ps3088/products_tech_note09186a0080094345.shtmlMind the word wrap.Chris M.
This sounds possibly like receive-side buffering. See this URL: http://www.cisco.com/en/US/products/hw/modules/ps3088/products_tech_note09186a0080094345.shtmlMind the word wrap.Chris M.
Randy, You can vary the clock rate on the physical DCE side of your back-to-back cable. Is that enough for you? I forget the speeds a 2500 will do, but you can verify this by typing "clock rate ?" to see the different speeds your 2500 will do.//CM
Hello, I've found that default-information originate only injects the default route into L2, and not L1. I'm replacing my L2 network with an MPLS VPN and running iBGP/eBGP. I need to inject a L1 default at the CE since my L2 connectivity is going...
