Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Customer has the same remote networks as some of my local networks. What is the best way to apply Nat accross the tunnel? 172.16.x.xlocal 192.168.0.0Remote 192.168.0.0172.17.x.xlocal 192.168.0.0Remote 192.168.0.0 LAN on both sides has 192.168.0.0 /24...
I'm migrating a Netscreen 10 config to a ASA 5510.I'm trying to understand Nat across the tunnel. LAN on both sides has 192.168.0.0 /24Currently, I have several tunnels that Nat Networks and hosts to 10.50.70.10 . I would like to to understand ho...
Customer has the same remote networks as some of my local networks. What is the best way to apply Nat accross the tunnel?I'm trying to figure out how to setup "Tunnel Nat" or Nat accross the tunnel.192.168.x.x, 172.16.1.x local192.168.x.x, 172.16....
I am trying to fix a similar situation. I need the "Masters" to review my configs so I can share the knowledge. I can get to the Internet from the DMZ and the inside interfaces. I'm trying to allow the inside interface to be able to access anything i...
I've heard that with a ASA 5505 the Security Plus lincese is required to pass traffic from LAN to DMA, DMZ to LAN. Is this the same with the ASA 5510?I have the ASA5510-Bun-K9 version
I'm working on trying this out. I feel confident about it and will let you know my results. Do you know of anyway to force a subnet...for example 192.168.0.0 /24 to translate to a host... 10.70.50.2? This could be 172.17.0.2 as in the above issue...
I have the same problem. 14 of the 30 tunnels I need to setup face the sames issue. The documents I've seen seem misleading...anyone have a good config example?
This appears to be a timing issue. Are the rekey values set to 3600 secs or 1 hour?If this is the case the traffic is normal however the NTP or Clock times on each end are off by 8 minutes.One solution is to use the same NTP server. The other would...
