Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am migrating a config from an old 2504 WLC (2011) running 8.5.140.0 to a newer 2504 (2016) running 8.5.161.0. I was able to save out a config from the old one and successfully load it to the new one, to my surprise.However, on the old install, I h...
Update here: I pulled the old WLC from service and put the replacement one in anyway. I added a test user to the old WLC and attempted to apply a qos role and it won't take on that one either. (Cisco Controller) >config netuser guest-role apply 000t...
Did a system factory-reset using 'Restore-Config'.Did setup wizard to bring up minimalist system, ignoring any prior configs.Created qos role.Set web-policy as the security for my test wlanCreated local net user, and attempted to assign qos role...sa...
Hm. Maybe - per my original post tho, I did try to assign via cli (and via GUI) same answer both ways. I’ve also downgraded the newer WLC to the same OS version (8.5.140.0), and the problem remains. So I can do it on one WLC but can’t on the other, w...
