Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
On our Head Quarter buildings we need to upgrade to 10Gbps connections and avoiding single point of failure nodes also.Refering to attached topo please, what equipments do you suggest invoking?-must have at least 2x 10Gbps interfaces-must be hotstand...
Hi.In one of our sites we added a second WAN line for backup because there is located call center dep. that are working with VoIP applic.On a 2800 series router I need to configure hot standby connection for 2 WAN lines with a possible minimum time s...
Thank you Steve.Our target is to secure our border equipments, regarding Telco conn. we are trusting coverage of SLA :-)We think going for 2 devices with 2 different Fo conn. per node, after them HSRP configured routers.We will welcome any other idea...
Please I need help regarding Stuckwise tech. So, if primary switch goes down, all Layer 1 connections of dead switch must be transfered to other alive switch manuallly, is this correct?Does exist any other technology to double switches per node (2 sw...
Thank you guys for your help.We need to build a L2 connection between buildings.Our budget is limmited to lets say 4500 series switchesIs it any technology that 2 switches will serve as one with hotstandby of each-other. So, if primary fails the 2nd ...
Actually, I have done that config but when switching from primary to backup line and vice-versa there is a slight timeout, about 3ms which cause drop of all active calls.Pls, any idea how to reduce switching time on possible minimum time?
Unfortunately its is not allowed by our security roules but if you help me with any example or any config it will be grat.Thank you again for your help!
