Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I had previously been using a Cisco 871 router as a Firewall/NAT/VPN router with ADSL internet service. The U-verse installation placed a 2wire residential gateway (RG) in between my 871 router and u-verse VDSL2. There is no bridge function like an ...
The only rate limiting that I can get to work is MQC (service policy) on a physical ethernet routed port but only inbound (traffic outbound from host). I need to rate limit in both directions. No rate limiting method works on a Vlan interface. the co...
I need to SNMP query a 2960 switch for and interface name, the up/down status of the interface, and the assigned vlan. I have figured out how to get the interface name and status but cannot figure out how to read what the assigned vlan id is. anyone ...
Now I have also found out that the 871 is not a terribly good performing router for 24 Mbps U-verse. I had lots of inspection lines, and some custom QoS, IPS, etc. I had to turn most of it off.I now have only these inspection lines. IPS, QoS is turne...
We'll I'll be a monkey's...I tried using the 871 again this morning with the 2wire RG. This time my router DID pull an address via DHCP. I followed the instructions for configuring DMZplus. It worked...for about 2 minutes.Interface F4 had received a ...
No I have never received a usable answer. Someone in NANOG claimed that he was able to get AT&T to configure his RG in a bridge mode. I tried the same with AT&T support and they are clueless. They claim they cannot do this and that I have to use the ...
