Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I'm trying to setup Client to Site VPN on RV340 and MAC High Sierra. I setup the client to site VPN configuration on RV340 and Cisco IPSec on the MAC. The client VPN shows connected, and this is the same when I check the VPN status on RV340 ...
I updated the FW yesterday and it seems to be OK.No other issues that I've noticedI can also connect to the client to site VPN even during busy work hours with high trafficI'll keep monitoring this.
Thanks for the response,I also thought it was the ACL, but it's the router itself. I previously added ACL to allow All traffic to a VLAN but that did not work, so I removed this ACL. There's very limited changes that can be done on the RV series...
After numerous troubleshooting, I was close to giving up. Then one step that I still had not done, to restart the router. After restarting the router, I was able to connect to the VPN and access the LAN computer via RDP without problems! The next ...
@verysiberian wrote:Update: I got this to work with my Macs and iOS devices, though it still does not fix the OP's original issue for using L2TP. Nevertheless, I am posting it here in case it helps others. Using the following procedure, I was able to...
