Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi folks,I have a mexpress controller with 5 1830 access points. I have been getting reports from users loosing wireless connection and have to reconnect again. and again. ======== start Part of the log:rever: mutex lock operation failed. errcode = R...
When I checked my ap config i got this: FlexConnect Vlan mode :.......................... Enabled Native ID :..................................... 1 WLAN 1 :........................................ 1 (Group-Specific) WLAN 2 :............................
Hi folks, After about 40 hours of all 6 APs being visible in the ME dashboard they have started disappearing again after a few minutes started randomly appearing in the AP list in the dash. I downloaded the Troubleshooting Tools and found this in the...
Hello Leo, Apologies if I did not mentioned the reboots. Frustration and tinge of panic can make me overlook things. I do not have the Management - Tech Support option the the Mobility Express interface. I do have the Advanced - Controller Tools - Tr...
Hello. Just and update. We were able to update the software to 8.8.120.0 but we are still getting reboots from four out of five APs -- blinking green light then blinking red/green light... The last four lines of the log:-----------------------D_ERR: ...
I have downloaded the 8.8.120.0 and will update the firmware. I used to update using directly from cisco.com but all it gives me now is DNS: IP address not found. In any case, I may have to update the APs individually as the WLC goes on and off as we...
