Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi There,I'm studying for my CCNA and I'm using boson Netsim 8 to try and expriment with setting up VTP. I have two 2960 switches and a 2811 router in the test lab.I have configurd the the trunk links and VTP OK but there are no updates between the ...
OK, so it appears that vlan information is passing between the server and client switches, I was so fixated with the VTP error that I did not check the VLAN status on the client. when adding a new vlan to the server it appears instantly on the client...
OK so I built a new test lab with just two 2950 switches, I habe recreated the VTP setup, set the VTP version to 2 on both, set the port speed & duplexand set the ip address on each VLAN1 interface. I also set the mode on all the other interfaces to ...
Hi Adam,Thanks for the quick reply, I have pasted the results of the show command on both ports.Switch2 (VTP Client)Building configuration...Current configuration : 54 bytes!interface FastEthernet0/1 switchport mode trunkendSwicth1 (VTP Server)Buildi...
