Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a UC500 thats been running for a couple of years now, in the last few weeks the moh has stopped working. When a call is put on hold the person on the other end simply hears a beeping. I have checked that the moh audio file is in the correct pl...
Hi,I have just set up my 1st ASA firewall. I have an L2L between my 2 sites setup without a problem. However when I try to use the vpn client, it connects fine but I cannot get access to the remote LANI have attached my config, can anyone tell me whe...
Is it possible to setup a site to site vpn with a pix501 when one site has has a dynamically assigned external IP? The pix is running verion 6.3, is there any other way around this that doesnt involve changing the config everytime the IP address cha...
Hi,I have a UC500 set up and don't really have many problems with it, but recently some users report that certain touch tone menus (eg when calling banks etc) don't work, they press the button nothing happens.Is there anyway to configure the settings...
**Reload of the system, by reload I mean a full power down and power back up, an IOS reload has never resolved this issue for me but a complete power down and up has **This fixed it for meThanks for your help
all endpoints are ethernet, all calls come in from pstn on fxo to auto attendant, no SIP trunks, no changes to paging groups.Only change recently has been addition of an analog phone on fxs port
I have attached the result of running show crypto ipsec saThis seems to show that no traffic is going across the vpn link, don't know if this gives anyone any ideas
