Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have always been able to dial SIP URI's from my SPA504G directly registered with various VoIP providers that I use.That is, until I upgraded from firmware version 7.4.7 to version 7.4.8.For the last few days I couldn't figure out why I was no longe...
This article may give a little more insight as to understanding dial plans:http://blog.cqvoip.net/2010/03/understanding-dial-plans-for-spa2102.htmlWhile that article is not specific to the SPA9000, I believe the fundamentals are the same.Here are a c...
This article may give a little more insight as to understanding dial plans:http://blog.cqvoip.net/2010/03/understanding-dial-plans-for-spa2102.htmlWhile that article is not specific to the SPA9000, I believe the fundamentals are the same.Here are a c...
I was among those who were having hang problems in the thread. However, not for some time now since I split my network configuration.One concensus was that DNS resolution may be an issue. Some people got around the issue by inputing proxy IP addres...
Sounds a lot like the nagging problems the SPA504G was recently having.See if any of the content in this thread sounds famaliar to you:https://supportforums.cisco.com/thread/2047249?tstart=0
I wonder if there is any correlation to lock-ups and SPA504's that are behind two NAT's?I was having periodic lock-ups while behind two NAT's. But, two months ago, I reconfigured my home network so that my SPA504 is only behind one NAT. I have not ...
