About kenpaul

kenpaul · 05-01-2022

Hello,Looking for help in setting up ISR 4351. We have two locations. Each location has: 1. An ISR with 3 physical interfaces2. Have /30 from ISP1 (x.x.x.x/30) and ISP2 (y.y.y.y/30)3. Have /24 Class (z.z.z.z/24) from ARIN that we are dividing in hal...

kenpaul · 05-02-2022

Hi Joseph,If ISP1 and ISP2 are sending us their regional routes, is it possible to use that data to route outbound traffic and then default to default route?

kenpaul · 05-01-2022

Thank you Georg! For the UTM, would I do set it up like this:Plug one of the WAN ports from UTM to GigabitEthernet0/0/2. Use IP address z.z.z.130/25 on UTM port with gateway IP of GigabitEthernet0/0/2? Thanks,Ken

kenpaul · 05-01-2022

Hi Jon— yes they are accepting /24 and /25. They are passing /24 out from their network and keeping /25 within their network that clarifies which location is advertising /25. It worked great when we only had one ISP. It should work the same with two.

kenpaul · 05-01-2022

Thanks BB! The UTM is Zyxel ATP. Yes, we would like failover solution. Here is the config I have on one of the ISRs: interface GigabitEthernet0/0/0description ISP1ip address x.x.x.x 255.255.255.252negotiation auto!interface GigabitEthernet0/0/1descri...

Member Since	‎09-18-2018 12:20 AM
Date Last Visited	‎05-06-2022 12:04 AM
Posts	5

User Statistics

User Activity

Dual WANs and your own Class C

Re: Dual WANs and your own Class C

Re: Dual WANs and your own Class C

Re: Dual WANs and your own Class C

Re: Dual WANs and your own Class C