Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Marcin / experts Can you please prepare a document on troubleshooting any issue across the VPN (from one ASA to another ASA / router ) which is related to following Or else if you can give a detailed explanation for troubleshooting that will al...
Hi experts ,i have couple of ques on the ASA Firewall performance parameters. a) There are some of the statistics mentioned below (highlighted in red ) from the output of "show interface " . can you please let me know what exactly does that mean and ...
hi experts,ASA is working in active standby failover and interfaces are being monitored with help of a snmp monitoring tool.When the failover occurs the ip address gets swapped and then it is not possible to get the information of the same ASA device...
hi expertsi was going through the asa documentation for snmp inspection and it doesnot mention much about snmp inspection . if the traffic is going from one snmp host to a destination snmp server passing asa , will inspect snmp required ? if yes , wi...
hi expertsi have a host and server in the same range sititng inside of firewall, is the below communication possible from inside host (10.10.4.3) to inside server (10.10.4.4) which belongs to the same range by doing destination NAT .Firewall inside i...
thanks kureli ! will wait for your views on this Hi julio,as per your below example , you have added transmitting and receiving bytes/ sec , but i doubt if it is true , i think that we need to just add either the receiving or the trasmitting bytes /...
Hi Marcin,I have been a regular viewer of your documents in the forum and appreciate your contribution . Can you please throw some light on how to evaluate performance or calculate the throughput across Site to Site VPN .For eg: usually we calculate...
Hi In cisco firewall , there is no concept of the Virtual IP in the Active - Standby failover . The IP address of the original active device gets swapped with the new active unit (previous standby).Can anyone throw more light on my query ?