Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there, I have a bit of a weird issue, last week we have decommissioned an old rack that had 2x ASA-5525-X units in it. I remember that the units where configured in Failover mode. But the admin who last configured these is no longer with the comp...
Hello,
I'm probably overlooking something here but I have a urgent need for blocking outside traffic to hairpin to a CME 12 router (ISR4331 with IOS 16). Since yesterday our provider notified us that we have a breach on this box that is being used t...
As I explained It boots and all status LED's are green the alarm LED is not active. Also as stated I think the box is faulty but at the same time when doing a Packet capture on the interface that was initially configured as the "Outside" interface I ...
Hi Balaji, Thank you for your reply, but as stated before there is no RTS on the Serial port so the standard procedures will not work.So We're looking for a way in order to regain access to the box or a way to figure out if the unit has some hardwar...
Hi Kasun, I dont think so, I have tried to do some captures on the 3x interfaces that are active (GE0,1,2) but exempt for the GE0 which is the WAN interface there is no response and on the WAN IP there is no SSH or ASDM enabled.
