Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Upon boot the LED indicator for WiFi on this ASA-5506W cycles through blinking green to blinking red. The documentation says it means "Ethernet link not operational". Since this is a hardware addon, I assume ethernet link is hard wired inside. To mak...
We have a new 5506-X with following:
ASA 9.7(1)4
ASDM 7.9(2)152
Our small office uses local isp with dynamic ip assigned to outside interface. Some dynamic ip service provides a constant url for access from internet.
Requirements:
They have a cu...
Sorry, I was away so could not respond. Problem as stated is ap does not allow enable. So I tried reset. It probably identified an issuebad mzip file, uncompressed to wrong length , (0x1cf119d != 0x1cf1660)Error loading "flash:/ap1g1-k9w7-mx.153-3.JC...
ASA2 is a backup we are testing config changes until the server can be published securely through ASA1.
192.168.1.15 <-> ASA2 <-> 192.168.29.0 <-> ASA1 <-> ISP
Thanks to your directions to diagnose the issue, I had the server admin show me netw...
192.168.1.15 can access internet - just installed tshark. But ping 8.8.8.8 from inside fails. Also on the ASA, I notice route to 192.168.29.31(outside) from interface group inside also fails. While wait, I will see if fixing that will make any dif...
Attaching the packet trace for following:
packet-tracer input outside tcp 192.168.29.222 443 192.168.29.34 443 detail
In my test setup, 192.168.29.0 is outside network with 192.168.29.34 is outside ip simulating isp assigned address.
Also attac...