I have an inside host ip and an outside host ip, i have a 3560 switch connected to a 2960 transmittor switch which is the inside network. Which is than connected to a 5520 ASA Firewall. For the outside network I have a 3560 outside switch connecting ...
Hi
I am trying to set up a STP with 2 3560 switches and I have 2 uplinks, I have made the trunk on both links, I am trying to figure out how I can make 1 link amber for both ports on each switch, I am not sure how to do that,
The end goal is so...
i made a command "spanning-tree mode pvst' how can i reverse this command? i now have all 4 lights green where there should be only 3 by default and 1 amber
id like to make 1 link green LED and the other link being amber, with a active/standby link so when i pull the active link out, the standby link takes over after 30 seconds, id like to express that both ports should be amber on each port for the link...