Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Upgrading IOS on several 2960X-48FPD-L switches. Running 15.2(2).E7, upgrading to 15.2(4).E8 (also tried E9 as shown below/attached). Using 'archive...' command, the copy job would seem to complete successfully, and then begin the copy a second time...
Hello, great guide, very comprehensive.It would be great if you could update to remove older Windows OS entries, and maybe add a section on integrating the Cisco switch config to customers running Aruba ClearPass instead of ISE.
It is a multi-vendor...
And right you are. Good catch. Re-checked the documentation and I was adding on the 'flash:'.I will have to test it out, but thanks again, and hope it solves the issue.
self-comment:I notice that the file is found, is copied, is extracted, and the /info file is examined.The issue appears to be this section:examining image...%Error, "flash:" is a directory.%Error, "flash:" is a directory.%Error opening flash:update/i...
