Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have the below topology in my prod environnement.
My objective was to establish EIGRP 10 between the routers and L3 core switches but,
The EIGRP between the Router and the L3 Core Switch in "Backup"/DR site is OK and functional.
But, when I act...
Hi guys,
I have my two Cisco L3 switches connected via a L2 link on which I activated EIGRP 10 and the neighborship is up.
vlan 50 : 172.17.192.128/25 --------[L3_SW_2] Fa0/24====L2====Fa1/0/48 [L3_SW_1] -------- vlan 50 : 172.17.192.0/25
The i...
Hi,
Here you go a design based on your requirement.
Hypothesis: you hav a core switch (Layer 3 switch) and the core switch connects to the ISP router on port Fa0/1, ISP router agree to use IP 1.1.1.2/24 and core switch will use the 1.1.1.3/24 ...
mljevakovic : thanks for your efforts. Finally, the issue was with the destination servers themselve. The default gateway IP was incorrectly configured by the system guy. Appreciate your efforts of building a lab based on this issue. Keep up that goo...
Hi Rick,Sorry for late reply as I was absent for a while.The scenario even for me was a "big" strange one! I've just checked with the system guy and apparently the default route was pointing to the Operator Router, instead of the L3 VLAN IP. I made h...
Hi Rick,
Unfortunately, I'ven't yet figured out the issue.
Here you have the arp table. For SW_1, I didn't put the whole ARP table (a large one).
L3_SW_L2#sh ip arpProtocol Address Age (min) Hardware Addr Type InterfaceInternet 17...
