Nexus 5000 Troubleshooting GuideLast Updated 02/07/2012By Steven TantiCustomer Support EngineerTable of ContentsDisclaimerCommon Error Messages1. Disclaimer The error messages and solutions in this document may vary depending on the code version...
From the port-channel summary I see the physical port is in "I" state. This usually means the port is not receiving LACP packets from the other side. (operationally individual). To confirm this, check with "show lacp counters interface port-channe...
Hello,Using LACP passive or active mode should not make much of a difference as long as one of the sides of the port-channel actively negotiates LACP. In most cases, we just configure both sides to be LACP active.When you say the port-channel is not...
Another way to easily tell if you hace configured Jumbo frames is to execute the following command and look for the section for qos-group 0 (which is the default class for all ethernet traffic):switch# show queuing interface ethernet 1/1Ethernet1/1 q...