Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've just upgraded a couple of our WDS master access points to 12.3(4)JA and find that they are no longer able to authenticate with wlse.Has anyone else seen this?Other access points are authenticating against the WDS master with no problem, but ther...
I need to clear out the rogue access point data from WLSE. There are now in excess of 30,000 rogue access points listed and Location Manager is struggling (running out of Java Heap memory). Any idea how to do this? Deleting them one at a time is goin...
Shame, there is at least on version 7.3 on our 5508s.Could also try "show capwap client config" on the AP. At least on the firmware we're running there's a "Led State Enabled" line in the output with the current LED state.
And just because it's not a supported configuration, doesn't mean it won't work... I never claimed it was "supported", whatever that means. (It's a perfectly valid bit of IOS config, just not implemented in the GUI, and our SE was aware of it at the ...
Surendra BG wrote:No its not possible... its always 1:1 mapping between the SSID and the VLAN in autonomous infrastructure..I can assure you that it is possible - we ran with two ssids on the same radio with different securiy settings for about a yea...
I have done this in the distant past.Don't think you can do it through the web interface, but from the CLI try putting the wireless sub-interfaces into the same bridge group.Afraid it's so long since I did this that I don't have a configuration fragm...
