Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone, I have a need to multihome out two MAN links to the same ISP. The two links will connect via an ISR and will participate in an eBGP adjacency. On the internal side, iBGP will be used to create the alternate default route to the ISP. E...
Hello Everyone,Has anyone else had issues with DTMF on the SPA525G2 when going out SIP trunks? I have a customer that we just rolled out 16 of these phones on a UC560 for. When hitting inbound our outbound IVRs over the SIP trunks, 3/4 of the DTMF di...
Hello,I am trying to add the business name to an outbound caller-id on a SIP trunk. The ip carrier allows this service in SIP traffic. Does this happen on the dial-peer?Thanks, Matt
Hello Everyone:I have been attempting to setup IPS from within CCA for awhile now with no luck. I own a contract and have downloaded what I thought were the correct files from within CCA. It seems like it is loading, then just goes blank. Has anyone ...
Yes Jcarvaja, HSRP is not a feature on the ASAs, and yes HSRP is difficult to setup natively to support active/active load balancing on any device. That's not really the point though is it. FHRP's are typically used for distribution switches and fine...
Hey David,I have trapped and packet sniffed both on the POP side and on the inside of the firewall. I can verify that the RFC2833 events and payload are going through and look identical (though you cannot determine the rtp payload type for DTMF from ...
Hey David,It seems that the (making an assumption here) firmware hard sets the rtp payload-type nte-tone, which is under the dial-peer voice xxx voip menu. You cannot set that from the ephone settings. I'm waiting back to here from the carrier as to ...
