Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloCould you tell me how to know which channel is being used by a wireless AP with the CLI interface ?Note: dot11radio interface is configured to be 'channel least-congested'Thanks !
Hello,I have two ISP circuits and the following devices in hand:1. Cisco ASA 55102. Cisco 2800 router3. Cisco 3750 switchI've finished a part of the configs on above equipments, please refer to the attached diagram.And I'm making a test in orde...
HelloPlease find the part of basic information about my current network design from below:1. Test-core-01 Vlan 110: 192.168.110.2/24 Vlan 901: 192.168.90.2/242. Test-core-02 Vlan 110: 192.168.110.3/24 Vlan 901: 192.168.90.3/24Diagram:I'm ...
Hello, there may be some problems with the ASA's config, but I can find where are the problems.Below is the basic config for this ASA:Inside ip address : 192.168.10.1/24Outside ip address: 120.195.153.151/26DMZ ip address: 192.168.30.1/24Web s...
I tried, and can get the information I need. Thank you all !Current Frequency: 2457 MHz Channel 10Allowed Frequencies: 2412(1) 2417(2) 2422(3) 2427(4) 2432(5) 2437(6) 2442(7) 2447(8) 2452(9) 2457(10) 2462(11) 2467(12) 2472(13)Listen Frequencies: 241...
Thanks for your quick response. I tried as your suggestions, but didn't get what I need. From below output , I can not know what is the current channel.>show logFrequency Carrier Busy %--------- -------------- 2412 3 2417 1 ...
Hi,Thanks a lot for your help . I created a new vlan(vlan 120) on core-02 and it's working now. If I also wanna vlan 110 can work successfully, is it possible to add the following commands on both core switch? standby 110 priority xxx standby 110 pre...
Hi, jenniferThanks a lot for your help . I think I have found where is the problem , just got reply from telecom company, the port 80 is blocked by them.
