Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,in campus I have virtual wlc (7.6.100) and 20 AIR-CAP1552E-E-K9 and 50 AIR-CAP1602E-E-K9. After some complaints from the clients that are just a few meters away from AP and on those AP's I don't have any clients. On vwlc everything seems fine, ...
Hi,how can I reset 1552 to factory default with console. I had mistake and install 1552 configured like ROOT AP and on the site I don't have a wire. Now I need to change AP mode to MESH AP becose AP join to wlc for some time and then disconect. I tri...
Hi, i plan implementation of WLC5508, but in documentation is not clear how to connect WLC5508 on two chassis for redundancy. I do it with WLC4404, where I have option to choose primary and backup port for managemant interface. I understand that in 5...
Is it posible to create a point to multipoint wireless bridge where remote location are on different networks.Currently I have a wireless bridge for one customer (ssid a), now I need to add another customer to the root. I think to make trunk (2 vlans...
Hi Scottyes, I set BGN and MAC address, I did everything I needed. I know that ROOT AP should failover to MAP and then you can just change mode, but AP join to wlc for some time (a few minutes) and I change mode to MAP but I think that the command ne...
Hi Weterry,you're right, I do not use LAG, I have the management interface (primary port 1 - backup port 2) that act like AP-manager and AP-manager 2 for port 2, just like I do on 4402, but sometimes the clients who are associated to the AP's that ar...
