Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I want to enable EEM. Trigger event is to down L2accessport in Another Switch. SwitchA,SwitchB assigment Tunkport(g1/1)and accessport(g1/2)Trunkport(g1/1) is directly connected each other.When it detects a down accessport(g1/2) in SwitchA, Enable EEM...
HiPlease teach me. How to implementation EEM.I want use EEM this situation.When gi1/1 detect down EEM scripts enable.In case gi1/1 is up within 3 seconds then finish the EEM scripts.Another case gi1/1 down time is over 3 seconds, Then shutdown gi1/2...
I think use a Ethernet CFM and IP SLAs for Metro-Ethernet this situation.http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/52sg/configuration/guide/E_OAM.html#wp1113912http://www.cisco.com/en/US/docs/ios/12_2sr/12_2srb/feature/guide/sr_m...
I want to how to detect goes down switchport each other.When switchA G1/2 goes down ,switchB detect the down G1/2 of switchA and shutdown G1/2 by itself.SwitchA version is SRD2,SwitchB is 12.2(52)SG1.
Thank you. And another question about How to enable EEM.SwitchA And SwitchB directly connected each other.Trunkport(g1/1) of SwitchA connected to Trunkport(g1/1) of SwitchB.When tracking interface(g1/2) is down in SwitchA, SwitchB enable EEM.Interfac...
