Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone, I have setup my ASA5506 as illustrated above. GigabitEthernet1/1 and GigabitEthernet1/2 are set to get IP assigned by 2 seperate ISPs through DHCP.I have my workstations connected through a switch to the GigabitEthernet1/4 of the ASA an...
Hi everyone,I have a web server sits behind an ASA5505, lets say it has the ip 10.0.1.10I have configured a NAT rule to forward port 80 from the outside interface , for example 54.55.56.57 to this server. it works flawlessly.However I have observed i...
Hi everyone,I have been struggling to get port forwarding to work on my ASA5505.So far I have setup an ACL to permit the port traffic and NAT rule to forward to port to the specific host.Packet tracer in the ASDM shows that the packet is allowed. How...
Thanks for the reply. Actually what I'm trying to do is, access the web server which is on G1/4 , using it's external IP , which is G1/2 from inside LAN that is on G1/3 , which uses G1/1 to get internet access.
Hi, I can use the private IP to access the web server without any issue. It's just being able to access the web server's public address is also required so now I'm still frustrated. On a side note, Accessing the web server's public address from the i...
Hi,Thanks for the NAT tip. However my 54.55.56.57 public IP actually comes from DHCP from ISP. I do not have a static IP at the momentIn this case, Can I bind the host to the outside interface instead of 54.55.56.57 for the NAT rule to work?
Hi Francesco, Thanks for the information but it seems I'm not allowed to section the "Translate the DNS reply for rules" checkbox which is somehow required to make DNS-Doctoring work. Is there something to do with my NAT?
