Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My company got a new Cisco router a couple weeks ago and I've been attempting to configure it whenever I have a chance to do so. I have managed to set up the interfaces and get my ip address set on the outside interface(eth0/1) but I am unable to get...
Alright, I got the ACL straightened out but still no access. I decided to run a connection test on the inside interface through the GUI and I think I might have came up with the problem, my static/default routes.My outside interface can run the test ...
That sounds like it could be right. I think I have it reversed at the moment and only have outbound on the LAN side set and inbound on the WAN. I'll test it out tomorrow morning, thanks.
I have set up the NAT like you said to but I am still not getting anything on the inside interfaces for the Internet. I can see that NAT translation is working as a lot of stuff is listed when I run the 'show ip nat trans' command, but it seems that ...
