Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,In the attached configuration I can see followingclass-map global-classmatch default-inspection-traffic!!policy-map global-policyclass global-class inspect ftpBut I am not seeing 'service-policy' command so without that policy is not going to ...
Hi,ASA doesn't support policy based routing. Here is a link for one document written by Cisco TAC engineer Poonguzhali Sankar, this document explains about the options available https://supportforums.cisco.com/docs/DOC-13015In the comments section on...
Hi,You can check 'show ver' for license information. On ASA5510 you can configure trunk and no. of vlans are 50 for base license and 100 for security plus license. And configuration is done in the way as mentioned in previous post. You may check lice...
Hi,It looks like you want to configure trunk and allow three Vlans (200, 201 & 202.... and possibly vlan:5 as well). On ASA5510 correct way of configuring trunk is to create sub-interfaces and configure Vlan on that. The configuration mentioned in y...
Hi,For accessing DMZ servers using public IPs instead of their private IPs, we will have to configure destination NAT for server. For example 11.11.11.11 is the public IP for DMZ server 10.10.10.10 then following static NAT will be needed to access 1...
