Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm quite a newbie to the IDS 4215 configuration; however, we just received ours in-house and I would like to run through the set-up with some experts prior to an extended test. My question, I have the cables from Fe1/1 and Fe1/2 plugged into two Gig...
Hopefully this is a relatively simple question, but I'm wondering which feature set I need to use MLFR with our Cisco 2620XM. We currently have it on a 2612XM; however, I need to set up a hot-site with the 2620XM and I can't get into the config on th...
Hello all,I'm trying to validate my configuration before going live and would appreciate if anyone could take a look and make recommendations. I would like to accomplish the following:1. Any External user connects to DMZ web server on port 80 (though...
You are exactly correct. Once posture assessment and authentication have occurred in an OOB mode, the end user is returned to an access VLAN (from the Auth VLAN) and the CAS is completely out of the picture. The only way to enforce traffic restrictio...
Hello - Which version of the Clean Access NAC software are you running? I would assume that you've got the voice vlan not being managed by the CAS; therefore, it would just be a matter of adding each mac address for all of your phones to the Device M...
Thanks. My FE0/0 is my management port and I will be using FE1/0 and FE1/1 for sensing (leaving open FE0/1, FE1/2. amd FE1/3 open for future use). I'd like to inspect traffic for a PIX firewall bound at 100Mbps, so I'm not losing too much in terms of...
Ignore the Fe0/1 interface since I just have it established for promiscuous mode monitoring. I would ultimately like to have this device perform in-line IPS functionality. Do I need to somehow return the packets from the "monitor session" commands is...
