Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All, I'm getting a bit stuck with the following configuration and I hope someone can help me. The configuration in the currently added drawing (See attachment) works properly but the following needs to be adjusted. The router in the top right (2...
Dear all, First off all I ‘am not a Firewall specialist. I have a configuration that is not working and I am out of options hot to fix my following strange issue. In use: One Public Subnet2 Cisco ASA's with firmware 9.xMultiple private ranges on both...
HI, I attached two files 1. Working Config_RTR.txt2. NOT working Config_ASA.txt I'm not in the office right now so i can not output "Show route" at this moment.
This is an International (Belgium - Netherlands) EVPN connection via multiple ISPs of which I cannot change the configuration. The problem is that the 0.0.0.0 route must go to 134.222.129.41 because the other networks are located there.
This is an International (Belgium - Netherlands) EVPN connection via multiple ISPs of which I cannot change the configuration. The problem is that the 0.0.0.0 route must go to 134.222.129.41 because the other networks are located there.
Thank you veryyyyyy much for you're help my two problems are fixed1. ASDM is working now, fixed it by going to conf t and type "ssl encryption aes128-sha1 aes256-sha1"2. SSH connection to 1.1.1.141 i resolved by you're advice "packet-tracer input OUT...
ASA-TEST# sh routeCodes: L - local, C - connected, S - static, R - RIP, M - mobile, B - BGPD - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter areaN1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2E1 - OSPF external type 1, E2 - OSP...
