Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Marcus, it all really depends if you already have Umbrella subscription for users/devices, or you just want to add DNS security to your Meraki LAN/wifi without that. If you do not have Umbrella, then easiest way is to use automatic integration wit...
Yes this is expected behaviour, traffic is bridged to the lan port of the AP tagged with the VLAN, if that does not exist it cannot reach its gateway so no traffic will be possible. After a while the client does a DHCP renew and then it works again.D...
Just to be clear, you mean that under Wireless - Access control at VLAN tagging you have tagged the AP per building and specified the VLAN ID to be used by building? In this case the VLAN for the SSID has to be present on the switch port. So that mea...
Otherwise do a visual check, on the AP reporting it at 40 dB, the interfering device must be very close to that one. Like a couple of meters probably. Could be anything like an AP, provider router, end-user 4G hotspot, some kind of smart device/tv.Or...
Hi NYMetsFan, under network-wide - general, what country/region/reg.domain is your network set to.This determines how loud your AP can go on power settings.Then my quick check about signal would be, when users are connected, go to the AP under Wirele...
