Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello , i have problem when i want to config limitation configuration on interface tenGige in Router NCS 540 appear this massage below :NCS540#CONFMon Feb 25 06:09:22.673 UTCNCS540(config)#policy-map 54STM-defaultpolice rate 8397 MBPSNCS540(config-p...
Thanks , i wrote the guide but i have misunderstanding with this command :police rate percent 20 burst 10000 bytes can you please explain it , where I put number of limit Traffic ?if i have interface TENGigE and i want limit its traffic to 54 stm how...
OK, but the router reject already the service-policy command !! how can I do what you write if i didn't put service-policy already in the router ?thanksAkram
Thank you to your response below what you want to shear : NCS540(config)#show configuration failedMon Feb 25 10:50:20.047 UTC!! SEMANTIC ERRORS: This configuration was rejected by!! the system due to semantic errors. The individual!! errors with ea...
