Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey guys,I am going to post this with only about half of the information needed to solve the problem but I just want to get the question out there. I don't have access to my config at the moment and I haven't had a chance to get to the console of thi...
Can anyone tell explain to me the difference in the two commands?I was having issues with some port forwarding where it was working, but shortly after the connection to the inside webserver was made any network off of the router couldn't be accessed ...
Hey guys,Quick question. I know it's not best practice but I have a network that currently all on VLAN 1 and can't be migrated to a new VLAN easily. Can I connect an access port in VLAN 1 to and access port on VLAN 20 on another switch? It's all the ...
Hello again,This is a continuation of my last post in which I need to apply ACLs to the physical ports within Etherchannels. The switch is a Catalyst 2970 running IOS 12.2. These Etherchannels are configured as trunks with 2 VLANS allowed on each tru...
Hello everyone,It's been awhile since I've had a project working Cisco equipment and I have a quick question on whether I can do something or not or how to get around it.I am using a catalyst 2970 switch for 2 vlans. Corporate data and a separate VLA...
Hello JanThanks for the reply on this.As per the last question about port forwarding using 2 NAT outside interfaces I currently have an internal FTP server and am forwarding port 21 using the I internal IP address for the outside interface.With my ne...
Unfortunately I can't change the rest of the switches on this network from VLAN1. These switches also connect to switches that aren't managed by me and getting all of these switches to match would take a lot of coordination. Things were setup very po...
Thanks for the quick response. As far as the logging is that just entries that are in the log file or does that also include match counts on an entry?Why would I only have 2 matches if it is clearly doing its job?Sent from Cisco Technical Support iPh...
What part isn't working? I usually use standard access lists for my NAT configurations.IP access-list standard (name)Permit (network) (wildcard bits)Sent from Cisco Technical Support iPhone App
