About D3savage

D3savage · 03-11-2019

Hi I am a bit of a super noob ...... the long and short is I purchased a second hand pre loved 3750G 24 switch for home use. In all honesty I don't really want to dig deep into cisco programming...although I can see lots of good things are available....

D3savage · 05-22-2019

Hi thanks for all your help so far ... I am busy at present but will get back onto it shortly.......... presently the good news is the switch is up and ....... running and it is quick. My whole network seems to have improved - I notice that my small ...

D3savage · 05-20-2019

Hi mark ..... I wondered this ......... all ports seem to be in zone 7???? I will try and get a comprehensive output - from the config so you can see - how it is set up. All I have done is do a factory reset - then sut up ip and default gateway .......

D3savage · 05-17-2019

Hi I did a sh power inline .................... all the ports in location 7 (which is 1-24) show n/a ......see jpg below.....whats going on this is supposed to be a poe switch .......... do I need to assign something to each port??? Can you help. How...

D3savage · 05-17-2019

Hi a quick question I want to try and apply the following command..........Switch(config)# int x/y Switch(config-if)# power inline port 2x-mode Switch(config-if)# shut Switch(config-if)# no shutOk ..... note I can get as far as the switch(config)# ...

D3savage · 05-16-2019

Hi ok .... switch all working it passes the unmanaged switches just great!!! Now all I need to do is get poe working...I plugged in an 802.af poe ubiquiti converter to drop voltage to 24v poe and plugged in my G3 camera in.....nothing.... can anyone...

Member Since	‎03-11-2019 12:45 AM
Date Last Visited	‎05-29-2019 12:06 AM
Posts	29

User Statistics

User Activity

3750G configuration

Re: 3750G configuration

Re: 3750G configuration

Re: 3750G configuration

Re: 3750G configuration

Re: 3750G configuration