I thought that both devices needs to be aware of each other to provide the roaming for the clients. Anyway the simple setup with WPA2/PSK on both devices works.
I will keep playing with WDS. Not that I need it :).
Thank you for the clarification.
... View more
Hi. 1. Questions: What is the diferrence between the following routers and will the later "Cisco 887 Annex M..." work with ADSL2+ line? I dont need inbuild wireless becuase I will purchase separe AP Also I dont need voice services as I run Asterisk Router Models $896.89 - Cisco 887VA 802.11n VDSL2/ ADSL2+ [C887VA-W-A-K9] $470.17 - Cisco 887 Annex M over POTS Multi-mode Router Advanced Security Feature set [CISCO887VA-M-K9] 2. Question Technically speaking what is better solution to buy? I am not sure, but the 800 series seems quite old today.How does it compare to 500 series? Is better to buy WAP4410N or 541N access point? Requirements: I have got block of IPs so I need to assign IPs to particular port numbers I dont need voice services on the router as I run Asterisk I would prefer to have VPN on the router VLANs I might have to add 1 more AP in the feature so wireless bridging would be good. Swill will provide PoE for APs. I would probably prefer IOS for configuration. Solution 1 $470.17 - Cisco 887 Annex M over POTS Multi-mode Router Advanced Security Feature set [CISCO887VA-M-K9] $421.90 - Cisco SG 300-10P 10-port Gigabit PoE Managed Switch [SRW2008P-K9-AU] $394.80 – Cisco 541N 802.11n Dual Band Wireless Access Point for Small Business [AP541N-N-K9] Is this AP 3x3??? Solution 2 $474.73 – Cisco SRP547W ADSL2+ Wireless-N GigE Modem-Router [SRP547W-E-K9] $421.90 - Cisco SG 300-10P 10-port Gigabit PoE Managed Switch [SRW2008P-K9-AU] $188.83 – Cisco WAP4410N Wireless-N Access Point [WAP4410N-AU] Adjustable and removable dipole antennas with multiple-input, multiple-output (MIMO) 3x3 diversity Question 3 Does Cisco SRP547W have IOS? Thank you Jiri
... View more
Hi. Please, can you explain why I am not able to select tunnel mode "ipv6ip" on my switch. I would like to configure tunnel from Hurricane tunnelbroker.net. switch-cisco-lab-cor(config-if)#tunnel mode ? aurp AURP TunnelTalk AppleTalk encapsulation cayman Cayman TunnelTalk AppleTalk encapsulation dvmrp DVMRP multicast tunnel eon EON compatible CLNS tunnel gre generic route encapsulation protocol ipip IP over IP encapsulation iptalk Apple IPTalk encapsulation ipv6 Generic packet tunneling in IPv6 nos IP over IP encapsulation (KA9Q/NOS compatible) switch-cisco-lab-core#show running-config interface tunnel 0 Building configuration... Current configuration : 203 bytes ! interface Tunnel0 description Hurricane Electric IPv6 Tunnel no ip address shutdown ipv6 address 2001:xxx:xxxx::2/48 ipv6 enable tunnel source 172.16.1.1 tunnel destination xxx.xxx.xxx.xxx end Switch Ports Model SW Version SW Image ------ ----- ----- ---------- ---------- * 1 52 WS-C3560G-48TS 12.2(53)SE C3560-IPSERVICESK9-M
... View more